Foshan Sunhope Co., Ltd.sales1@fs-sunhope.comWhatsApp +86 189 8867 9216WeChat shan285397003
Get a quote

CAB or Vacuum, Continuous or Batch: Choosing a Brazing Furnace for Radiators

By the Sunhope engineering team · · 2 min read

Short answer: most aluminium car radiators and AC condensers are brazed in a nitrogen controlled-atmosphere (CAB) furnace with non-corrosive flux. Choose vacuum brazing only when your customer or drawing requires a flux-free process. Choose a continuous mesh-belt furnace when you can keep it loaded with similar parts, and a batch furnace when output is low or the mix of parts changes often.

The furnace is usually the largest single investment in a radiator plant, and it decides how many cores you can make per shift. It is also the hardest machine to change later, so it is worth settling the process and size early.

CAB and vacuum brazing

Nitrogen CABVacuum brazing
How the oxide layer is removedNon-corrosive fluxMagnesium in the alloy, under vacuum
AtmosphereNitrogen, very low oxygen and moistureHigh vacuum
FluxYesNo
Typical partsCar radiators, condensers, heaters, many intercoolersFlux-free parts, some plate-and-bar and specialty cores
ThroughputHigh with a continuous beltLower, batch loads

For a standard radiator or condenser line, CAB is the usual choice. The core and brazing alloys you buy must match the process, so tell your material supplier which one you use.

Continuous or batch

  • Continuous mesh-belt furnace: parts move through flux, drying, brazing and cooling zones on a belt. Best when you run steady volumes of parts that share a temperature profile.
  • Batch furnace: one load at a time. Best for low volume, prototypes, or very different parts that each need their own profile.
  • What sets output: belt width, belt speed and how closely parts can be spaced at a qualified recipe, not the furnace length alone.

What to tell your supplier

  1. Largest core size, especially height, which sets the chamber height.
  2. Target output per shift and the mix of parts.
  3. Power available on site and whether you can supply nitrogen of the required purity.
  4. Floor length available: a full continuous line with flux and drying zones is long.

Our brazing furnaces

Each furnace is configured to your product size and output. Send us your largest core size and target output, or build your line online. If a furnace stops heating evenly, see our guide to brazing furnace phase failure.

Frequently asked questions

Can one furnace braze both radiators and condensers?

Often yes, if both fit the chamber and each part has its own qualified temperature profile and loading pattern.

Why does the nitrogen purity matter?

Oxygen and moisture in the brazing zone stop the filler from wetting the joints, which causes weak or leaking joints.

Do you install and commission the furnace?

Yes. Our engineers install the furnace, set the temperature profile with your parts and train your operators.

Machines in this article

All aluminium brazing furnaces →

More from the blog

All articles →

Planning a radiator line?

Pick your machines step by step, then send the line to our engineers.

Build a line →